Jeep TJ Front Tube Fender DIY Highline 97-06 Wrangler TJ/LJ Under Cover Fab

Jeep TJ Highline Tube Fenders with 4 inch Flares DIY Kit is shipped unassembled and must be welded by the customer. Each side is assembled from (2) pieces of 1/8 inch steel plate and (1) 1 1/2 inch x .120 inch wall DOM tube. They bolt to the tub in...
$587.99

Under Cover Fabworks

Tube Fenders

-
+
$580.00
Real time +55 visitor right now

Jeep TJ Highline Tube Fenders with 4 inch Flares DIY Kit is shipped unassembled and must be welded by the customer. Each side is assembled from (2) pieces of 1/8 inch steel plate and (1) 1 1/2 inch x .120 inch wall DOM tube. They bolt to the tub in 4 places at the firewall, to the inner fender in 6 places and to the grill. They were designed in 3D modeling software to follow the contours of the hood and still provide protection against trees and limbs.

The contour of the hood is offset 6 inch to the outside of the flare (flare is only 4 inch wide at the back) to protect it from the tires in compression or articulation or other obstacles. Fender clearance is increased by about 4 1/2 inch from the best clearance spots in the factory fender.
The fender is 1 1/2 inch tall from the grill to the curve at the rear of the fender. You will have to modify your factory fenders to install these new rock fenders, however you will maintain full engine bay protection unlike some other tube fenders.

You will be required to trim about 3 1/4 inch off the bottom side of your hood to install these parts.
Details:

  • 4 inch flare
  • Fender clearance is increased by about 4 1/2 Inch
  • Shipped Unassembled
  • Must be welded by customer

Recently Viewed Products